Waveshare Dual Gigabit Ethernet Base Board for CM4

DescriptionDual Gigabit Ethernet Base For CM4Suitable For Evaluating The Raspberry Pi CM4 Or Being Integrated Into End ProductsPowerful Ethernet CapabilitySpecificationsCM4 SOCKETsuitable for all variants of Compute Module 4ETHERNETDual Gigabit Ethernet RJ45USBUSB 3.2 Gen1 × 3PIN HEADER40PIN GPIO header × 1HDMIHDMI × 2, supports 4K 30fps outputDSI DISPLAYMIPI DSI display port × 1, 15pin 1.0mm FPC connectorCSI CAMERAMIPI CSI-2 camera port × 2, 15pin 1.0mm FPC connectorPOWER INPUT7V-36VFAN5V/12V, allows speed adjustment and measurementRTCReal-time clock with battery socket and ability to wake Compute Module 4SD CARD SLOTMicroSD card socket for Compute Module 4 Lite (without eMMC) variantsConnecting With Compute Module 4Standard CM4 Socket And Color-Coded Raspberry Pi 40PIN GPIO Header Suitable For Compute Module 4 Lite/EMMC Series ModuleRich InterfacesProviding Interfaces Including: ETH/CSI/DSI/RTC/HDMI/Micro SD/USBWhat’s On BoardCM4 socket suitable for all variants of Compute Module 440PIN GPIO header for connecting sorts of HATsRJ45 Gigabit Ethernet dual RJ45 Gigabit Ethernet, 10/100/1000M compatible ETHERNET 0: CM4 original ETH ETHERNET 1: USB extended ETHUSB 3.2 ports 3x USB 3.2 Gen1, for connecting sorts of USB devicesHDMI connectors 2x HDMI, supports 4K 30fps outputCAM 2x MIPI CSI camera portsDC power supply 7~36V DC wide voltage range power inputDual LED indicators red: Raspberry Pi power indicator green: Raspberry Pi operating status indicatorMicro SD card slot for connecting a Micro SD card with pre-burnt image (Lite variant ONLY)FAN header for connecting cooling fan, allows speed adjustment and measurementDISP0 MIPI DSI display portUSB SLAVE port for burning system image into Compute Module 4 eMMC variantsRTC battery holder supports CR1220 button cellRTC interruption configuration PI-RUN: CM4 will reboot on RTC interruption GN-EN: CM4 powerdown on RTC interruption D4: D4 pin is triggered on RTC interruptionIO-VREF selection set the CM4 IO logic level as 3.3V or 1.8VFAN power supply selection select 5V or 12V power to drive the fanSystem function configuration BT_DIS: Bluetooth disabled, for CM4 with antenna variant ONLY WiFi_DIS: WiFi disabled, for CM4 with antenna variant ONLY WP_DIS: boot mode switch, ONLY be used when NOT booted from eMMC or SD cardRTC/FAN I2C bus selection SDA0/SCL0: I2C-10 is shared with CSI/DSI GPIO3/2: I2C-1 is shared with 40PIN headerRTL8153 USB Gigabit Ethernet chipEMC2301 fan controller, allows fan speed adjustment and measurementVL805 USB 3.0 HUBOutline DimensionsApplication Examplefor reference only, CM4, display, cameras, and fan are NOT included.Resources & ServicesWIKI: CM4-DUAL-ETH-BASE* Resources for different product may vary, please check the wiki page to confirm the actually provided resources.